Mahr MarSurf CD 120 / CT120 Complete System Contour and Surface Measurement System

Mahr

Mahr MarSurf CD 120 / CT120 Complete System

For sale is a professional contour and surface measurement system from Mahr,
consisting of several devices, accessories, calibration standards, and extensive
training materials.
This is a high-quality laboratory or quality measurement system for precise analysis
of surface geometry, contours, and measurement parameters.

Main Device:

Mahr MarSurf CD 120 (Contour Measuring System)
CNC contour measuring device with vertical axis system
Precise measuring module with stylus holder
Granite measuring plate with guides
Suitable for contour measurements on technical components

Typical Measurement Ranges:

Vertical (Z-axis): approx. 60–120 mm (depending on model)
Horizontal (X-axis): approx. 100–120 mm
Extremely high accuracy due to granite base and play-free guides

Control Units:

Mahr MidRange / MidRange CNC (Type MCP-22 / MCP-23)
Control and operating unit for the axes
Interface to measurement software (MarWin / MarSurf XC)

Mahr ST 500
External control or sensor module (often for special probes)

Software and Documentation Status

MarSurf XC2 V. 3.01–03.4
MarSurf XC20 V. 5.00–10.1
MarWin v13.20-07

Operating manuals, training folders, training materials
Measurement examples, diagrams, technical instructions

This software is designed for the evaluation of contours, profiles
and surface parameters.

Accessories / Measurement and Calibration Parts
Stylus and stylus arm sets

Precision styli of various shapes and lengths
Replacement needles and assembly tools
Stylus holder with protective box
Calibration and reference bodies
Mahr Contour 2 Block with reference ball

Calibration and Parameter Data

For PCV, CD 120, LD 120

CDs and data carriers with parameters and software
Transport and protective covers
Several original cases with foam inserts
Calibration seal/test label visible (valid until 2026)

Typical Voltage Data of the Mahr MarSurf / MidRange / CT Series
MarSurf CD 120 (Contour Measuring Device / Axis Drive)

Power supply via control unit
Internally typically: 24 V DC
Power supply externally via MidRange control unit

Mahr MidRange Control Unit (MCP-21 / MCP-22 / MCP-23)
This device is the central power supply.
Typical values:
Primary: 230 V AC / 50-60 Hz
Secondary: 24 V DC (regulated)
Power consumption: approx. 40–80 W

Mahr ST 500
Also connected to the MidRange system
Supplied via 24 V DC

CT120 / Touch Systems
Sensor technology operates with low voltage 5–24 V DC
Powered by the main device (no separate power supply)

Accessories, handheld control units, interface boxes
Usually 5 V or 24 V DC, depending on the module

Weight: approx. 65–73 kg

Important Note:
“The table shown in the photos is not part of the sale.”

Condition: used

Scope of delivery: (See image)

(Changes and errors in the technical data are reserved!)

Further questions can be answered by phone.