Robust double roll cutting and winding machine cutting machine FSM 15-II #1

Robust Roll Cutting and Winding Machine

Here we offer a Robust cutting machine.

Double cross-cutting unit; double material roll holder with
double rewinding and transport belt unit with adjustable drive.

Robust cutting machine control, table, and control cabinet

Machine data:
General:
Power connection: 3 x 400 V + N + Earth; 50Hz
Protection: Min. 3x25 A / 10KVA (see electrical control)
Operating noise: Lpa = 74 dB(A) DIN 45635
Ambient temperature: +18 to + 24°C
Compressed air connection
Compressed air: Min. 6 bar
Compressed air connection: NW 13mm
Air consumption normal filter: Approx. 100 - 150 l/min

Double cross-cutting unit
Machine width: 1500 mm
Max. material width: 1450 mm
Power connection: 3 x 400 V; 50Hz
Protection: Min. 3x25 A (see electrical control)

Double material roll holder with double rewinding
Unwinding
Max. roll diameter: 500 mm
Max. roll width: 1450 mm
Max. roll weight: 500 kg
Core inner diameter: 3" = 76.2 mm
Rewinding
Max. roll diameter: 200 mm
Max. roll width: 1450 mm
Max. roll weight: 50 kg
Core inner diameter: 3" = 76.2 mm
Transport unit with adjustable drive

Double material roll holder with double rewinding
Two roll holders and two rewinding units are each driven by a
frequency-controlled drive motor. The unwinding speed
is regulated depending on the dancer position in the corresponding
dancer device. The rewinding for the separating film is driven by
a frequency-controlled drive motor with torque control.

Cutting machine "ROBUST FSM 15-II"
The cutting machine "ROBUST" type FSM 15-II is a special version,
equipped with 2 feed and cross-cutting units each.
The cross-cutting units designed for guillotine cutting have
one geared brake motor each for cutting execution. The movable upper blades
are guided in play-free precision ball round guides.
The guide plates on the lower knife carrier and on the
knife beam are non-stick coated and partially equipped with an
air bubble device.
The drives for the lower feed rollers are provided by one stepper motor
each. Length measurement is done via the stepper motors with the
corresponding electronic control.
The non-driven upper feed rollers are pneumatically pivotable
and adjustable on both sides with pressure.
The machine operates in cycles. After a start pulse, a format
is advanced and cut.

Transport belt unit with adjustable drive
Consists of a pneumatically pivotable transfer conveyor belt and
a subsequent take-off conveyor belt. The transport unit is driven by
a geared motor. The incoming format is detected by
a sensor, the format is pre-transported to the transfer position
and released for lifting.

Electrical control
The control is designed as a multiprocessor control with multitasking program,
i.e., independent controllers are provided for the essential functions,
which communicate with each other via a master computer.

Type: FSM 15-II

Scope of delivery (Robust cutting machine, material roll holder, transport belt unit, control)

(Changes and errors in technical data are reserved!)
 
We would be happy to answer any further questions by phone.